Self-drilling stitching screw with shank reamer and EPDM
Reduced drill point for stitching thin metal sheets. Dimensions, performance and application conditions refer to the specified Tecfi execution.
Tecfi PLC01
- Reference
- Tecfi PLC01
- Thread
- Self-drilling stitching
- Drive
- External hexagon
- Units
- mm
Representative geometry photograph. Material and finish are specified separately.
Technical drawing and legend
Tecfi PLC01
Drawing not to scale, extracted from the Tecfi technical data sheet.
- Ø
- Outside screw diameter
- A
- Width across flats
- B
- Integral flange diameter
- B1
- EPDM washer diameter; PLC01 version only
- L1
- Threaded section plus point; to be specified for the requested execution
- L
- Required length, to be specified in the quotation
Dimensions
Nominal dimensions in mm for the specific Tecfi execution. The source does not give numerical tolerances for these dimensions; no generic tolerances or DIN/ISO equivalences are assigned. Confirm the execution drawing in the quotation.
| Ø | A | B | B1 |
|---|---|---|---|
| 4,8 | 8 | 10 | 14 |
Separate washer: bore Ø 5.1 mm, outside diameter B1 = 14 mm.
Materials and finishes
| Component / material | Finish / execution |
|---|---|
| Case-hardened steel screw | Zinc plating 8 µm, CrVI-free |
| Pre-galvanized steel washer with EPDM seal | Preassembled |
Data refer to Tecfi PLC01. Dueemme confirms material, finish and actual availability in the quotation.
Documentation
Download Dueemme data sheet ↓| Document | Status |
|---|---|
| Declaration of conformity | Subject to order agreement |
| Material certificate | Subject to order agreement |
| EN 10204 2.2 test report | Subject to order agreement |
| EN 10204 3.1 inspection certificate | Subject to order agreement |
| Dimensional inspection report | Subject to order agreement |
| Coating report | Subject to order agreement |
| Other documentation | Subject to order agreement |
Batch documents are not automatically included: specify your requirements in the RFQ.
Drilling and application conditions
| Parameter | Value for the specific execution |
|---|---|
| Minimum metal substrate | 0,6 mm |
| Maximum drilling capacity | 2 mm |
| Drilling speed | 1800-2500 rpm |
Characteristic mechanical data
| Parameter | Value |
|---|---|
| Mt (Nm) | 8,9 |
| Nk (kN), s = 2 mm | 2,2 |
| Nk (kN), s = 1 mm | 1,8 |
| Nk (kN), s = 0,6 mm | 1,5 |
| Vk (kN) | 0,62 |
Mt: breaking torque, not installation torque. Nk and Vk: characteristic tensile and shear breaking loads, not allowable design loads. Values apply to the documented execution; connection verification must consider sheets, thicknesses, geometry and installation conditions. In the performance table, s denotes the supporting sheet thickness. Control tightening to compress the seal correctly without damaging it.
Request a quotation
Specify type, diameter, required length, quantity, material and finish, plus the material and thickness to be drilled. Dueemme will confirm execution and availability.
Send your request