Hexagon flange head - HI-LO - pointed
Direct fastening into plastics. Reference geometry: Kilton 165. Check the component material, pilot hole and assembly conditions.
HI-LO
- Geometry reference
- Kilton 165
- Thread
- HI-LO
- Drive
- HEX
- Units
- mm
Technical drawing and legend
Kilton 165 drawing, not to scale.
- A
- Width across flats
- B
- Flange diameter
- H
- Head height
- U
- Flange thickness
- R
- Underhead fillet radius
- D1
- Major diameter of the low thread
- D
- Major diameter of the high thread
- d
- Minor diameter
- P
- Pitch between high-thread crests
- Z
- Axial extent of the point
- L
- Length to specify in the enquiry; reference as shown in the drawing
Dimensions
Dimensions in mm, except drive size. Min / max pairs are dimensional limits for Kilton 165. A dash means the manufacturer does not state a value. Specify the required length in the enquiry.
| Nominal diameter | A min max | B min max | H min max | U min | R | D1 | D min max | d max | P | Z max |
|---|---|---|---|---|---|---|---|---|---|---|
| 5 | 6,78 / 7,00 | 9,50 / 10,00 | 3,30 / 3,80 | 0,80 | 00,70 | 3,79 | 4,80 / 5,10 | 3,00 | 3,00 | 3,70 |
| 5,5 | 7,78 / 8,00 | 10,00 / 11,00 | 5,15 / 5,45 | 1,00 | 0,60 | 4,29 | 5,30 / 5,60 | 3,50 | 3,00 | 4,30 |
Materials and finishes
| Material | Finish | Source |
|---|---|---|
| C1018-C1022 steel | To be specified in the quotation | Kilton 165 |
Dueemme confirms material, finish and availability in the quotation. Steel execution dimensions do not automatically apply to stainless versions.
Documentation
Download Dueemme data sheet ↓| Document | Status |
|---|---|
| Declaration of conformity | Subject to order agreement |
| Material certificate | Subject to order agreement |
| EN 10204 2.2 test report | Subject to order agreement |
| EN 10204 3.1 inspection certificate | Subject to order agreement |
| Dimensional inspection report | Subject to order agreement |
| Coating report | Subject to order agreement |
| Other documentation | Subject to order agreement |
Batch documents are not automatically included: specify your requirements in the RFQ.
Application guidance
Pilot hole and assembly torque depend on the polymer, fillers, wall thickness and boss geometry. Validate fastening on the actual component; do not automatically apply metric screw tightening torques.
HI-LO and 30° screws have different profiles. PT, DELTA PT and ecosyn plast trade names do not establish automatic equivalence with the geometry shown here.
Request a quotation
Specify diameter, required length, quantity, material and finish, together with the component polymer and service conditions.
Send enquiry