Terminal crimping dies
Dies for crimping terminals with the B12 hydraulic tool, sold separately. Select the pair by terminal outside diameter and rope diameter.
- Material
- Material not specified in the source sheet
Technical drawing
Illustrative drawing, not to scale. Dimensions in mm unless stated otherwise. This does not replace the operating instructions supplied with the tool.
Technical drawing
D: terminal outside diameter before crimping; d: rope diameter. Table covers B12 terminal dies; oval-ferrule dies are a separate series. The updated source specifies Ø 6.4 mm for MINI 4; verify compatibility with any nominal 6.5 mm terminals. Confirm compression count, spacing, final across-flats dimension and procedure for the selected terminal. For MINI 4 the source gives conflicting crimp widths (6 and 8 mm); no inferred procedure is published.
Variants and dimensional data
| Type | Terminal outside Ø (mm) | Rope Ø (mm) | RFQ |
|---|---|---|---|
| MINI 2 | 4,8 | 2 | |
| MINI 3 | 5,5 | 2 / 2,5 | |
| MINI 4 | 6,4 | 3 | |
| MINI 5 | 7,5 | 4 | |
| MINI 6 | 9 | 5 | |
| MINI 8 | 12,5 | 6 |
Specify the tool, rope, ferrule or terminal and die in the enquiry. Compatibility must be checked for the complete system.
Materials and finishes
- Material
- Material not specified in the source sheet
Material of the documented configuration. Specify supply conditions and finishes in the enquiry.
Documentation and supply
State the quantity, application and documentation requirements in your enquiry. Availability and configuration are confirmed for the individual requirement.
Request a quote
Terminal crimping dies